Serenity MQZDV1917 Instruções de Operação descarregar pdf (Página 9)

Figure 4 - Cabinet mount configuration.

Figure 3 - Stud mount configuration

The Stud Mount configuration is for instances where facing material will be used. This includes dry-

wall, granite, slate, marble, brick, and various other combustible and non-combustible materials. To

mount the unit to a stud, simply bend the Back Tabs forward in the position shown in Figure 3. The

Front Tabs maybe bent forward to clear a way for access to the screw holes. Using the holes provided

on the Back Tab, fasten the unit to the studs with the appropriate eight [8] screws.

For Cabinet installations, bend the Back Tabs back flush against the side of the unit. Using the holes

on the Front Tabs, fasten the appliance to the Cabinet with the appropriate eight [8] screws.

Clearance to Combustibles

Table 1 - Clearance to combustibles for fireplace appliance.

Back 0” [0cm]

Side (from standoffs) 0” [0cm]

Floor 0” [0cm]

Minimum Ceiling Height (from bottom of fireplace) 44” [112cm]

Top (from standoffs) 0” [0cm]

Top of 90

Bend 3” [7.6cm] All Vent Systems

Top of 90

Bend over 44” [112cm] Enclosure 2 1/2” [6.4cm] All Vent Systems

Top of Horizontal Pipe 1 1/2” [3.8cm] All Vent Systems

Side & Bottom of Horizontal Pipe 1” [2.5cm] All Vent Systems

Vertical Vent Pipe 1” [2.5cm] All Vent Systems

Vertical Vent Pipe 1 1/4” [3.2cm] Simpson/AmeriVent/Selkirk

Direct Temp Systems

NOTE: The Front Tab can be cut and discarded in the Stud Mount configuration.

NOTE: Before fastening the mounting screws, ensure that the unit is level.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 49 50

Sem comentários

Serenity MQZDV1917 Instruções de Operação Página 9